The max number of iterations is dictated by the number of accumulators in the hardware accelerator. Interference statistics (which uses the accumulators) determines the threshold values to be used in ...

I have written a javascript for adding breakpoint and reading a variable value, using DSS API. As of now I am running that script from scripting console of CCS using loadJSFile command. As I run the ...

This e2e post provides some options in how to clear the alert. Keep in mind that the default hysteresis for 411 is 10C. The signal will remain on until the temperature is past 10C the set Therm limit.

If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

The random explosion occurred during the power on and off. We observed that the PWM could not be turned off normally to 0V, but was stuck at 5V. This caused the MOS to fail to turn off normally, ...

I am facing following problems while installing the MacOS installer of MCU-PLUS-SDK. It says the .dmg file is damaged and it cannot be installed. Could you please check this.

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

I have built an 8-to-1 inverting summing amplifier using OPA820 where, R_f = R = 1K (unity gain). However, I can see a reduction in pulse fall-time which I don't understand. Does anyone who the reason ...

Need your help to check below problem. V_CP1 is about 23V. This is for high side current sensing application. CS3_SP4 and CS3_SN4 are connected to a shunt resistor. When there is no current flow into ...

In the reference design TIDA-01022, if the SYSREF of the ADC12DJ3200 is implemented as a single pulse clock, does it mean that only DC coupling can be used with the LVPECL interface? What should be ...

We are trying to program CDCE925PWR clock chip using CDCEL9XXPROGEVM but when we connect the programmer it gives an error in device manager "Windows cannot verify the ...

I set up the simulation for bidirectional current measurement as per datasheet, figure 7-6. However, the simulation does not work. It works fine, however, when only connecting one INA301. I used the ...