I have written a javascript for adding breakpoint and reading a variable value, using DSS API. As of now I am running that script from scripting console of CCS using loadJSFile command. As I run the ...

The max number of iterations is dictated by the number of accumulators in the hardware accelerator. Interference statistics (which uses the accumulators) determines the threshold values to be used in ...

This e2e post provides some options in how to clear the alert. Keep in mind that the default hysteresis for 411 is 10C. The signal will remain on until the temperature is past 10C the set Therm limit.

The random explosion occurred during the power on and off. We observed that the PWM could not be turned off normally to 0V, but was stuck at 5V. This caused the MOS to fail to turn off normally, ...

We are trying to program CDCE925PWR clock chip using CDCEL9XXPROGEVM but when we connect the programmer it gives an error in device manager "Windows cannot verify the ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

Need your help to check below problem. V_CP1 is about 23V. This is for high side current sensing application. CS3_SP4 and CS3_SN4 are connected to a shunt resistor. When there is no current flow into ...

[ 1.277602] mdio_bus 8000f00.mdio: MDIO device at address 1 is missing. [ 1.284288] davinci_mdio 8000f00.mdio: phy[0]: device 8000f00.mdio:00, driver RTL8211F Gigabit Ethernet [ 1.293743] ...

Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...