Blend door motor - Jeep Wrangler Forum
2019年12月18日 · Ok ive searched and not came up with a solution for say. I replaced my blend door motor cause it was clicking and yep teeth missing. Was good for about 2 months then it started clicking again. Took it out the other day and made sure it was good yep it was. Put it back in and the clicking gone, three days later it's back.
2016 JKU Cabin Heat Blend Door Motor | Jeep Wrangler Forum
2023年11月28日 · When my blend door actuator stopped working, I got a bonus sound in the form of a squeak along with a blinking light on the HVAC controls on start up to indicate a fault. Testing with JScan confirmed the source of that fault to the blend door actuator.
Jeep JK A/C Blend Door Actuator Replacement
2019年6月8日 · A/C blend door actuator in your Jeep JK is a very important part of the heating and cooling system and is responsible for controlling the temperature of the air blowing thru the vents and into the cabin. To blow heat into the cabin, the blower motor sends air through the heater core and on through the dash vents.
Blend door - Jeep Wrangler Forum
2024年1月15日 · So you need to check the voltage both at the panel connector (C-2) & also at a light green connector (C205) that runs under the dash I think on the passenger side between the panel & the blend door motor connector for voltage. You will be looking for a damaged/broken wire/melted connector somewhere between the panel & the motor in the variable ...
Blend Door (with pictures and the common problem)
2011年10月23日 · The Blend door actuator is a motor driven positioner, a dc motor controls direction and the gearing to a potiemeter provides position feedback, to the climate control module. To test the system if your blows just hot or just cold all the time, do the following. If yours system blows cold.
Need to replace JK blend door actuator, is OEM worth 4x...
2021年4月16日 · It's an inexpensive design but puts stress (full motor torque) on the plastic gear teeth every time the unit self-calibrates (which is often.) No wonder the light-duty gear teeth eventually fail, I'm guessing almost always at one end of travel or the other (i.e. the point where the blend door travel limit is detected.)
Ac door blend actuator - Jeep Wrangler Forum
2022年7月6日 · So I searched through a little bit and found an older post about the ac door blend actuator and I was wanting to ask on it, but then at the bottom it said that it was older and to start on new one. So here goes. I have put in a new door blend actuator on my dads 2015 wrangler unlimited rubicon because the old one was stuck in the heat position.
Blend Door (with pictures and the common problem)
2006年6月4日 · Before buying a new blend door motor assembly, try and FIX IT! My mother has a '94 Oldsmobile 88 that had the same problem with the broken gear. The blend door motor assembly looks just like the one posted here. I made a REPAIR on the assembly this morning without having to purchase a new part.
Air Recirculation Door Clicking (Actuator?) JKU 2013
2018年2月17日 · I disconnected the door electronics and undid the strap so I could swing the door out of the way and give myself more room to work. You need to remove glove box, then the 3 7mm screws holding the lower dash. Followed by the speaker. It is held in by 2 7mm screws that are under the end panel on the dash, and one larger 10mm one on the bottom.
Blend Door Actuator - Jeep Wrangler Forum
2016年8月24日 · I ordered a new actuator and it did not move either. I also replace the blower motor relay because I saw a schematic that indicated one leg of the relay went to the blend door actuator. Still no movement. The connector on the blend door actuator has 3 wires, orange is hot, black/white is ground and yellow is the control to the temp control knob.